LIVEWIRE
ARC CHASER/Dual Mode TDR/Aviation Version
Part #:
LW-AC120AV Manufacturer part #:
LWAC120AV
Unit Quantity:
1.00
Min. Order Qty:
0.00
13.00
To order, contact us now
MAP:
0.00
1 877 524 8100
The Arc Chaser Dual Mode TDR provides fault testing and monitoring in energized and un-energized cables up to 600 Volts. It can monitor live cables for intermittent arc faults and capture when and where they occur using advanced spread spectrum time domain reflectometry (SSTDR) with accuracy to fault better than 1%.
- This device can easily verify the quality of an entire length of cable and it works on both energized and non-energized cables so that events that only appear under load can be detected
- Monitors intermittent arc faults, opens, and shorts and displays the results in a graphic or text format with a clear and simple overview of the faults
- Uses an SD card for memory so that users can save reports on the device or transfer to PCs for storage and/or printing
- Equipped with a cable test setup that walks users through the setup process
- No metrology calibration is required, this device self-calibrates to maintain accuracy over time or in response to environmental change
- Provides English and metric measurements
- Equipped with a color touchscreen display that's easy to navigate in all lighting environments
- Modular cable interfaces for connection to many different types of systems
- Meets international requirements for working on energized cables, 600V CAT III
- Rechargeable lithium-ion battery pack provides 8-10 hours of battery power
- Comes with a waterproof/shock-resistant transport case that keeps equipment protected even in harsh conditions
- Uses upgradeable firmware
Power:
Wall power voltage input range: 10 to 28V, 20W
(Arc Chaser will run with wall power down to 4V, however batteries will not charge unless input voltage is greater than 10V)
Totex battery pack, with four LIO rechargeable cells
Full screen brightness, dynamic test, 7.8V battery: 335 mA
0 to 00% brightness, @7.8V: 90 mA
Typical battery current: 185 mA
Low power mode (or timed out): 70 mA;
Off mode: 420 μA board (+500uA battery pack circuitry)
Maximum range:
12,000 ft (3,657 m) at 0.999 VOP
Maximum testable cable length varies with VOP and cable type
VOP (%) with 3 digit precision ranging from 20.0% to 99.9%
Output connector:
Banana jacks 600V CAT II
Leader cable:
cable assembly, 5 ft. (1.5 m) 600 volt CAT III, 95 Ohm
Battery Life: